TheBlackSheep Posted July 20, 2010 Share Posted July 20, 2010 Gentlemen, (I hope I'm not using that term to loosely) I have just begun my foray in to rifle cartridges. I am encountering two main problems thus far; first I am acquiring dents up on the shoulder of about 10% of the brass. I understand that this maybe from overuse of lube, however can it be a symptom of another problem? Are these dented rounds otherwise safe to use or should they be disassembled ? The second problem I am experiencing is with my RT 1200B gets substantially warmer than one would expect. I measured the temperature with a thermometer and was astounded to find that after two minutes it was around 120 and after five minutes it was holding at 150, with no load. It goes with out saying this caused some alarm. Link to comment Share on other sites More sharing options...
Religious Shooter Posted July 20, 2010 Share Posted July 20, 2010 I would say that the hotness is normal. I would agree that the dented shoulders could be because of too much lube. And unless you are loading near the edge, dented shoulders are OK to shoot. Back in the day when I shot and could afford factory I shot dented Winchester Q3131A (a hot factory round) without any problems. Link to comment Share on other sites More sharing options...
TheBlackSheep Posted July 20, 2010 Author Share Posted July 20, 2010 No they are not hot rounds, just paper killers..... Link to comment Share on other sites More sharing options...
D.Hayden Posted July 20, 2010 Share Posted July 20, 2010 150 seems too hot, that fast - after a while, mine will climb to 140-145 - but not that fast Link to comment Share on other sites More sharing options...
Religious Shooter Posted July 20, 2010 Share Posted July 20, 2010 Well... what was the weather like when it was measured? It's like 100 degrees right now in So Cal. If I trimmed right now I'm pretty sure it will get hot pretty quick. Link to comment Share on other sites More sharing options...
High Lord Gomer Posted July 20, 2010 Share Posted July 20, 2010 I have never measured the temp but mine does get HOT. Running the vacuum cleaner does seem to help pull some cool air through it. Link to comment Share on other sites More sharing options...
sleepercaprice1 Posted August 7, 2010 Share Posted August 7, 2010 In my experience, dented shoulders are usually the result of excessive lube. It's also possible that there may be media or other crud accumulated in the die. I'd try spraying out the die with brake cleaner and visually verify that that the die is clean. As far as the trimmer motor getting hot, I've noticed the same thing. I've never checked it with a thermometer, but it definitely gets warm. Link to comment Share on other sites More sharing options...
calishootr Posted August 14, 2010 Share Posted August 14, 2010 +1 to the excessive lube, you can take apart the die and use brake clean on it, or on the next series of rounds going in, not lube them as 'liberally' to get some of lube out ofthe die without taking it apart, long as the rounds arnt really hot, or the dent big enuff to interfere with chambering??? you should be good to go Link to comment Share on other sites More sharing options...
Big Bore Posted August 14, 2010 Share Posted August 14, 2010 Mine 1200 gets real hot also. After a 1000.223 brass its alost too hot to remove from the press. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now