markimm

So, little bit of knowledge here. The gear box in the manual is NOT the same as the gearbox in the DC version. The premature wear on the gearing caused by this is going to be an expensive lesson.

Does not require the use of caliber specific inserts. The only thing you change on the Rollsizer unit is the drop tube between small/large pistol and small/large rifle. The tube is the same as the rollsizer itself so they can be used in either machine. Decapper die is the FW setup with the self centering shuttle.

Something new coming

Not shelved, but there are parts that are currently out of stock with no date of expected return. No backorders are being taken on them because no idea when they will be available again.

None of your Ammobot sensors or case kicker will work on the new machine. They have completely abandoned any and all support for the Ammobot.

It will not work. The 1100 and 1050 use entirely different bottom ends. The old PW on the RL1050 will not work due to dimensional changes to the press.

Pistol only. For 9 it works as long as you don't overload it with too much brass. I have found that more than about two handfuls clogs it up pretty bad and it doesn't work well. For 45 ACP, it is very limited in how much brass you can put in there. All the 45 ACP cases stand up on the plate real quick and block the channels from letting upside down brass come down the tube. It will jam. Did it several times yesterday while pushing capacity on a standard unmodded Dillon DC motor. Original AC motor in the Dillon feeder is about useless, not enough torque to deal with that many slots full and dragging on the bowl floor.

That wiring mod bypasses the over current detection of the motor control board, not a good idea. Dillon will definitely stop replacing them if they see the mod done..pretty easy, all they have to do is make you send back the cable that was cut and deny any warranty.

There is a 10mm adapter in the box to use a power drill. Do NOT put a motor on it, the gear box is not made to do that...no, the gear box in the DC and manual units are not the same.

Do you mean the RL1100? There is a video on the same youtube that shows how to do the same thing with those.