mtwain56

Don't know Phx, but if Tempe is convenient look up True Shot gun club (trueshotgunclub.com)

Thank you. Thank you!

I've been using Tite Group for a couple a years. Have not been able to get any locally for a while so I'm thinking about making a change in powder. It seems VV N320 is mentioned a lot and I'm considering using it. Other possibilities are Win 231 or HP-38. I cant find any load data on manufactures' web sites using standard 124 RN FMJ, it also seems most of the threads on "The Forum" discuss coated 9mm bullets for pistol along with PCC. Load data for 9mm minor, 124 FMJ RN is what I'm looking for. Thanks for reading this, Larry P., Super Senior Plus (age 81)

Try using the identical brand & type brass.

Weak recoil spring could be it, but what is your load data, bullet gr, powder & amt, and OAL?

This forum is a great resource. Thank you.

I thinking about using a reduced power firing pin spring in a stock G17 with my own reloads with S&B Primers. I'm wondering how they compare in hardness to Federal SPP's.

I searched TTI first! The way I read it they don't sell a spring for the +3/4 extension, they recommend Glock 17 round OME.

Thanks for this web address. WOLFF Springs...I couldn't remember their name. Good place to shop!

I shoot G17.5 w/ Trijicon RMR 2. Using TTI+3/4 and they have been problem free.

My TTI+3/4 base pads for my Glock 17 have been good to me...but my Glock mag springs are worn and OME springs are not available locally. Can anybody recommend a good aftermarket company that sells mag springs as reliable as the Glock springs.

Called RCBS Monday, their representative sent me RN plug free of charge. Received it Friday! That's great customer service!

Thanks, for confirmation. Got to get a RN.

Thanks, for that info!

Thanks, just checked Dillon web site and I see what your saying. Checked RCBS also. They don't say it specifically, but mention another seater plug could be needed. I'll call them on Monday.

Trying to get a OAL under 1.130, and seat the bullet without flattening the the round tip. The dies I purchased were used so I don't know if the Seater plug insert is right for round nose bullets. Could it be for Flat Nose or Hollow Points? I'm using mixed brass, and Berry's 124 RN which are .356 in diameter.

Ditto, just give them a little twist!

Right on...IMHO doing a reload with a 10 rounds stuffed tight in the mag, and on round already in the chamber is asking for a malfunction.

Picked up 115 gr 9mm polymer coated bullets. I'm using TiteGroup and going to use these for target practice. Any recommendations for amount of powder, and OAL?

Actually, looks the same (w/ polygonal rifling), fits & chambers the same . Bringing it to IDPA intro course next week. If there is any problem with 23/19 I'll post it here.. Thanks again, LP

Small Pistol, What brand is No. 500, not Federal?

I'd want to shoot IDPA with my "carry" gun which is compact Glock 23 ".40 caliber" converted to 9mm. The barrel is not Glock OME. The Rule for ESP says: "Replacement of barrel with one of factory configuration that uses a stock or non-stock cartridge." What does that mean? My question is Is it ok?

Thanks to all contributors for solutions and information. What worked for me: 1) lowered my resizing die all the down. and 2) for some brass, running them through the resize die before I actually begin reloading. Thanks again to all.

Welcome to the Forum. I shoot at Rio Salado Sportsmans Club in Mesa.