AK-Monkey

Recently had the same issue where my trigger would "hesitate"/not reset. I had to manually flick the trigger forward to complete the reset. Unfortunately this was during a match. After a bit of troubleshooting, I found the same issue as JonasAberg - the screw holding the trigger bar spring was loose and was not providing enough upward force to reset the trigger bar. Tightened it down and back to normal.

If you have a cajun kit installed, specifically the adjustable sear, you will be able to engage the safety

The only reason I have for a rear sight is the pistol may or may not be used for matches and if for some reason, I need need to remove the optic, I still have the option to shoot it and not have a gaping hole there until I replace it. Kinda a dumb reason, but looking for options.

I am wondering if there is anyone out there who will mill a SP01 for an optic who can also make a filler plate with the rear sight if the optic was removed similar to the Shadow 2 set up. I saw CZ Custom does something like this but seems like they are the only ones I can find. Any one know of other options?

I believe they were made by Novak. If you go to their website, you should be able to find them. I think these are it, but not 100% sure https://www.novaksights.com/Detail.aspx?PROD=1100739&CAT=9531

Mt 2 cents - I have tried these: CMC PCC trigger AIM Surplus POF All of them ran just fine in the PCC's they were in. All three have had about 500 rounds or more through them with no issues. Of the three, I prefer the CMC.

Been long enough since I installed it I honestly don't remember. I do recall I had to give it a few light taps with a rubber mallet to seat it.

I have a TTI magwell on my 5 inch Pro and there is not a gap in back after it was installed. I do recall it was a very tight fit to get on.

I have a 2.5 MOA on a 1st gen 5" CORE and a 5 MOA on a 2nd Gen 5" CORE. Both are my C/O pistols. I did have an issue with my 5 MOA where the negative terminal broke off and had intermittent power. Trijicon replaced it. Fluke I guess. Both have run fine over the last 2 seasons.

I have one on a 1.0 and it does lock up pretty tight. The end of the funnel meets up with the grip fairly well where I did not notice any hanging up of the magazine. may need a little blending - YMMV. Not a bad magwell at all.

TTI has a magwell for both the 1.0 and 2.0. I have a 1.0 and fits tight. Funnel blends fairly well with inside of grip.

I can second the Strike Industries +5 extension. The package is listed as for a P-10F mag, but technically the same mage. I did not measure OAL though.

Did you mount the Fire4Effect one on a TSO? Looked at their website and it didn't look like it would fit the TSO. Just wondering.

The OEM TSO thumb rest sits a bit far back for my liking and removing it, although more comfortable, seems a bit lacking. Another member here suggested trying a type 3 thumb rest. Does anyone know where to find one of these besides ordering from outside the country?

Been looking for a different thumb rest as the factory one seems to be a little too close for me. How is the IPSC Alex thumb rest compared to the factory one besides being wider? Is it a little more forward on the frame than factory?