Already took care of that part, dillon actually sent me some new thicker bars and it helped alot.
A few flakes of powder trickler out of the powerder funnel after I lower the ram, I can see it happen, this happens because the vibration from operating the press causes a few flakes that were hung up in there to fall. If you look at the inside of your powder funnel and the steel tube above the powder funnel they are both very rough on the inside, this is where the powder is hanging up then falling from vibration.
My question is how do I smooth up the inside of these two parts, polishing at this point won't work because its way to rough and its very difficult to get in there.
Take yours apart and look at it, I bet its the same, I don't know why they manufacture them like this?