onebadeye
-
Posts
149 -
Joined
-
Last visited
Content Type
Forums
Profiles
Events
Store
Everything posted by onebadeye
-
Will my 38 special - 357 dies be OK to load this cartridge.
-
Thanks Dave I'll have have no regrets going with the best.
-
Thanks guys, I'm going to try them hoping he makes them for pmc also I have lots of it.
-
Can anyone tell me where I can get original hearthco moonclips for starline brass, and what thickness of moonclips for federal and pmc brass.
-
I load 3.3 with a 147 bayou at 1.135 for my g34 and never had issues.
-
Thanks will check gas rings
-
Carrier is not moving at all , gun was shooting fine last week .
-
Bolt not moving when firing a round. Gas tube is clear and clean , any suggestions on what may be causing this.
-
I do have mags, I must keep them out of my state . They are 38 super , but run the 9's .was hoping to get some 10 rounders to try and sell it. Don't shoot it.
-
Does anyone make a good 10 round 9 mm mag for caspian hi cap ..
-
Thanks all, broke rifle in today. One shot and clean three times, then five shots and clean nine times . Hope that will do it , four hours at the bench.
-
How important is it, for a new rifle.
-
I love mine also, will shoot it in uspsa matcches because I like shooting it. Mine is going noplace.
-
Thanks I have an assortment from 40gr to 69 gr.
-
Can anyone tell me the preferred bullet weight for1 in 8 twist 16" ar 15 in 223 cal.
-
Thanks again glad to here that, since I have 1 1/2. 5 gallon buckets of it
-
Thanks it is federal brass
-
I have some once fired 223 brass from police range, after sizing case length is only 1.738 - 1.742 are these ok to reload.
-
Solo 1000 for coated, titegroug for jacketed
-
Yes, I know I can use it. Was wondering if anyone gets good accuracy with it
-
Anyone use this powder in 223 with 52-69 gr. Bullets.
-
I agree I will be getting the sti.
-
Thanks, I have several custom 1911 guns , nothing in 9mm.
-
Thank you, that's what I did. Just making sure
-
Thinking about getting one in 9 mm for steel challenge . Anyone shoot one , or should I go with ago.