Trimmy

I have a 1000 PD 180grn FPRN and I am using WST. I have a newborn and not a whole lot time to get down and work up a bunch of loads for what I am looking for so hoping someone can give me a base line of where to start. I am using a G22 to shoot GSSF and will also be using it as a duty weapon starting around December so I do not want to change springs or modify the gun in anyway. I want to know if anyone has a load that will cycle a stock G22 reliably but is still relatively low recoil. Any help is appreciated Thanks Jusitn

The worst part for me is my Fiance will not allow me to put this stuff in our spare spare bedroom that is empty right now so I have to make a cover for it all to keep it clean.

Well here is my 650 setup on my bench. Took a little modifying but I LOVE the setup how it is. No strong mount in my future!!!

The fascination is its the only thing I rarely see on shelfs other then bullseye which is even more rare.

The guy that I finally talked to was very nice and did everything he could, and even waited on the phone for the email to go through just to verify for me they received it.

I called the other day to have my military discount added to my account so I could order my new 650. I waited on the phone for over 30 minutes... It if did not save me over $100 there is no way in heck I would have been on the phone that long.

I ended up order a Dillon 650 with the case feeder, roller handle and powder check. With my bench I'm going to try it without the strong mount. The additional 8.5" I just feel will make it uncomfortable for me. I plan to add a 1/2" steel spacer on the top of the bench and a small 1/4 steel spacer on the bottome so I can still use the loaded round bin and it will also make it rock solid with as stout as I built my bench. In the next month I hope to add a 40 and 45 conversion, tool head, and powder measure for both calibers so I only need another $500 lol

I have a propane torch not a heat gun and its a one time deal. Didn't hurt the kydex at all.

I bought it from Shooters conection and the only option they have for it is the pro/L 5" option. Just looked at the packaging and it is for a pro only. I did get it to fit just fine with a a small amount of heat.

Looks like the front of slide is rubbing really bad towards the bottom of the holster causing it to hang up. I took my propane torch and heated the bottom up a little bit and started working it until it fit good. The front ofmy slide does rub a very slight bit I'm sure after some working it will be fine.

I hope one day I can afford one of these.

VERY NICE

Holy crap there are some sweet guns in this thread!!!

I just bought a Bladetech DOH for my 9L. The one I have says its for a Pro 5" or a 9L. MY 9L does not fit, I had to loosen it up all the way and it still does not fit well. I have to really push it in and its very hard to get out. Any one else having any issues with their Bladetech? The one I have for my Glock fits just fine.

I had to leave about 30 thousands shoulder on my 200grn SWC, anything less and it would catch on the barrel of my TLE. .30 and more it feed absolutely flawless..