racesnake Posted December 11, 2003 Share Posted December 11, 2003 Can anyone advise me on mounting a Docter sight on a 9mm Glock. *Which adapter do I need and where do I get it? *What are the machining cuts and screw hole spacings? *Are the slides hard - can they worked with normal end mill cutters and thread cutting taps? Any help will be greatly appeciated. Link to comment Share on other sites More sharing options...
Flexmoney Posted December 11, 2003 Share Posted December 11, 2003 The surface of the sldies are very hard. Any machinist that isn't used to working with them usually ends up cussing a bit. Link to comment Share on other sites More sharing options...
vluc Posted December 11, 2003 Share Posted December 11, 2003 Novak's Handgunner Outlet Doctor low mounts Link to comment Share on other sites More sharing options...
George Posted December 11, 2003 Share Posted December 11, 2003 IMHO, melting in one of these in is not a simple thing. The cuts on the one I had done are not that straight forward looking. Try Gramms Engineering, or JP Rifles. All of the dovetail adapters are a bad choice because they raise the sight so high that you might as well use a C-More. Regards, Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now