kalebg Posted August 4, 2009 Share Posted August 4, 2009 Are Dropped and Offset Holsters Legal for Production? Thanks. Link to comment Share on other sites More sharing options...
Singlestack Posted August 4, 2009 Share Posted August 4, 2009 (edited) Yes. Holster restrictions •Suitable for everyday use. “Race gun” type holster prohibited. •May not be manufactured or cut lower than, and must cover the slide up to, ½” below the ejection port (belt slide “Yaqui” type holster exempt). •Revolver holsters open no lower than halfway down the cylinder. Edited August 4, 2009 by Singlestack Link to comment Share on other sites More sharing options...
00bullitt Posted August 4, 2009 Share Posted August 4, 2009 YEAH.......what Singlestack said But they also cannot offset more than 2" from the inside of the inner belt as stated in appendix D and shown in Appendix E2 Link to comment Share on other sites More sharing options...
wgnoyes Posted August 4, 2009 Share Posted August 4, 2009 But they also cannot offset more than 2" from the inside of the inner belt as stated in appendix D and shown in Appendix E2 Well, neither can anything else in any other division. Link to comment Share on other sites More sharing options...
mhop Posted August 4, 2009 Share Posted August 4, 2009 i think if people measured this it would be interesting to them i know on the glock and m&p doh holsters with a cr speed belt the techlock attachment sets it to far out but the stringray is good Link to comment Share on other sites More sharing options...
Singlestack Posted August 5, 2009 Share Posted August 5, 2009 i think if people measured this it would be interesting to them i know on the glock and m&p doh holsters with a cr speed belt the techlock attachment sets it to far out but the stringray is good I would never take one to a match that I didn't measure. Link to comment Share on other sites More sharing options...
00bullitt Posted August 5, 2009 Share Posted August 5, 2009 Actually the Tek Lok is fine. Measures just under 1 7/8" The Stingray is 1/3/4" Link to comment Share on other sites More sharing options...
staudacher Posted August 6, 2009 Share Posted August 6, 2009 My DOH blade tech holster for my SIG X-5 pushes the gun out to 2 1/4" with a Stingray attatchment and a CR Speed belt. So I ditched the blade tech DOH and made my own out of a piece of kydex. Now I am at 1 3/4". Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now