Nemo Posted October 12, 2007 Share Posted October 12, 2007 Putting together another 1911 with parts already owned. The slide will get a Novak rear sight cut and a Heinie LoMount to fit. If you know or have a similar setup, please tell me what front sight height I should get. THX! Link to comment Share on other sites More sharing options...
benny hill Posted October 12, 2007 Share Posted October 12, 2007 There is no good answer to this as it depends on how far the barrel locks up, trigger jerk, etc. Try a .165 & go from there. Link to comment Share on other sites More sharing options...
Dan Sierpina Posted October 12, 2007 Share Posted October 12, 2007 Most front sights are .187 high. Although, as Benny said, it depends on the lockup where the final height will be. Link to comment Share on other sites More sharing options...
Nemo Posted October 12, 2007 Author Share Posted October 12, 2007 Thanx guys. I kinda' knew it would vary but I needed to know if I had to start with a .200 or the lowest available. Link to comment Share on other sites More sharing options...
Loves2Shoot Posted October 12, 2007 Share Posted October 12, 2007 I just get tall ones and then cut them down to the height I want, it is simple that way. Link to comment Share on other sites More sharing options...
ogiebb Posted September 11, 2009 Share Posted September 11, 2009 this is the thread i was looking for..Thanks Nemo Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now