5.56 Guatemalan Brass

[monkeywrench]

Im sure its been covered already, but I can't find the topic on Guat. brass flash holes. I have an RCBS Universal Decapper, and sure enough the flash hole in the Guatemalan 5.56 is too small for the decap pin. Is there a smaller pin I can replace it with? I don't feel like drilling out many many holes.

[Mr. Chitlin]

I just give the handle a good push and it punches right on through. I've punched a ton of 'em.

[amlevin]

I just give the handle a good push and it punches right on through. I've punched a ton of 'em.

Same here.

[Ron Brooks]

Say, I looked for this Guatemalan brass at Widener's and couldn't find it, at least listed as such. Is it listed as the once fired?

Any one here know?

Thanks

Ron

[Religious Shooter]

It's in their specials page.

http://www.wideners.com/itemdetail.cfm?item_id=6846

Get 'em while you can. That's pretty cheap for new .223 brass.

[Ron Brooks]

AHA!!, thank you. I keep looking under the reloading components.

It's in their specials page.

http://www.wideners.com/itemdetail.cfm?item_id=6846

Get 'em while you can. That's pretty cheap for new .223 brass.

[chunger]

Darn, out of stock

[Mick]

I took one of my decapping pins and tapered it to a smaller point.

I never had a problem with smaller flasholes again...