renaissance7697 Posted April 4, 2007 Share Posted April 4, 2007 BE: ( or anyone who knows) Do I remember correctly; that you once said that there was/were "special" parts for use in the dillon 3 die set for when loading > Hard Cast Lead "FULL Double Ended Wadcutters" in 38 special ( for use in S&W 52-2 ) Seating stem ?....Crimp ????.....?????? Link to comment Share on other sites More sharing options...
Meangun Posted April 4, 2007 Share Posted April 4, 2007 BE: ( or anyone who knows)Do I remember correctly; that you once said that there was/were "special" parts for use in the dillon 3 die set for when loading > Hard Cast Lead "FULL Double Ended Wadcutters" in 38 special ( for use in S&W 52-2 ) Seating stem ?....Crimp ????.....?????? The seating die has an insert that has a flat botton vs. the recessed bottom for Flat Points etc. There is a pin that is pulled out of teh seatind stem and the insert swapped out. I use my 550 w/ case feeder for my 52. Link to comment Share on other sites More sharing options...
dillon Posted April 4, 2007 Share Posted April 4, 2007 You just need to swap the bullet seat stem for the one that is perfectly flat across the bottom. Probably no changes are necessary to your crimp, but a light roll crimp for revolvers, or a taper crimp for S&W Model 52's is ideal. Be sure you are flaring case mouths at least .010" to be sure you don't shave anything off the sides of the bullet when seating. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now