bp78 Posted August 3, 2006 Share Posted August 3, 2006 Let me preface this post by acknowledging that I need to do a better job of riding the safety. Normally I do ride the safety and have no problems. However, I still occasionally make the mistake of not getting my thumb back over the safety after a reload quickly enough or don't position it right when shooting from-retention stages. (IDPA) The safety on my Armscor 1911-A2 is loose and easily pops-up into safe during firing. Any suggestions on making the lever more positive? I'm not much of a garage-smith, but part of buying the Armscor was so that I wouldn't feel too bad tinkering on it. I'd also consider swaping out the stock ambi safety for a smoother single-side safety (although that might make IDPA weak-hand stages more difficult) Thanks. Link to comment Share on other sites More sharing options...
Flexmoney Posted August 4, 2006 Share Posted August 4, 2006 You might be able to make a little divot on the front of the safety...where the spring loaded nub from the safety plunger tube make contact? Link to comment Share on other sites More sharing options...
Matt Cheely Posted August 4, 2006 Share Posted August 4, 2006 (edited) You might be able to make a little divot on the front of the safety...where the spring loaded nub from the safety plunger tube make contact? Yep, with the guts out of the plunger tube, put the safety in the down position and push a drill bit through the plunger tube to make a mark on the safety. Take safety off of the gun and make a small divot. The deeper the divot, the stronger the safety will want to stay down. ETA: Here's the "correct" tool for the job. Edited August 4, 2006 by Matt Cheely Link to comment Share on other sites More sharing options...
bp78 Posted August 4, 2006 Author Share Posted August 4, 2006 You might be able to make a little divot on the front of the safety...where the spring loaded nub from the safety plunger tube make contact? Yep, with the guts out of the plunger tube, put the safety in the down position and push a drill bit through the plunger tube to make a mark on the safety. Take safety off of the gun and make a small divot. The deeper the divot, the stronger the safety will want to stay down. ETA: Here's the "correct" tool for the job. Thanks guys. I'll give this tip a try. Link to comment Share on other sites More sharing options...
ArnisAndyz Posted August 4, 2006 Share Posted August 4, 2006 If you have any trouble ask Ivan (Blackdragon), he'll set you strait. You could probably just send him the safety to trade out for another one. Link to comment Share on other sites More sharing options...
Carmoney Posted August 5, 2006 Share Posted August 5, 2006 Within the range of possible fixes, replacing the plunger spring would be the cheapest and easiest.....you might want to start there first. Good luck! Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now