Scope Mount For The Older Sw K Frames?

[bountyhunter]

I was looking for a standard Weaver type rail mount that screws onto the top of an older "K" frame that does not have the three holes in the top strap (the old ones just have two)..

Aimtech makes this Frankenstein monster that bolts onto the whole right side of the gun, but I was hoping somebody made something simpler that works with the two holes in the top strap.

Any suggestions?

Edited March 20, 2006 by bountyhunter

[Gillster]

B-Square makes one that works pretty well. Brownells might sell them, if not B-Square has a web page. I have had one on an older 686 for years.

Chris

[bountyhunter]

B-Square makes one that works pretty well. Brownells might sell them, if not B-Square has a web page. I have had one on an older 686 for years.

Chris

I found the B-square web site to be 100% useless. I found B-square mounts sold at various places with B-Sq part numbers that do not appear on their site. There is no search engine or full catalog of their mounts.

The 686 is an L-frame, do you happen to know which of their mounts would fit an old-style K frame?

[AzShooter]

The old Weaver mount for the 10-22 will work with just the two holes. Make sure you use the blue loctite to keep it there.

[Gillster]

The scope mount works on K/L/N frame alike since it uses the same hole and recess as the rear adjustable site. Here is the Brownells page for it: B-Square Scope Mount

I used the same mount on a 625 before parking it on a 686-3 for good. Hope that helps.

Chris

[bountyhunter]

The scope mount works on K/L/N frame alike since it uses the same hole and recess as the rear adjustable site. Here is the Brownells page for it: B-Square Scope Mount

I used the same mount on a 625 before parking it on a 686-3 for good. Hope that helps.

Chris

Thanks.