New 1301 Comp Pro extended tube?

[Rudukai13]

I have a new 21” 1301 Comp Pro and I’m looking for a mag tube extension for it. I’d prefer it to be roughly even with the muzzle of the 21” barrel, but if I had to choose would prefer it be a little bit longer than the muzzle.

 

What should I get? Follower? Extended spring?

 

Thanks in advance!

[Nolan]

I run Nordic Components MXT extensions on all of my 1301's.  They have years of the typical 3-gun abuse, dumped in all kinds of barrels, knocked off gun racks, etc... and are still holding up fine.  One stop shopping, MXT +3 tube, spring, and cap.  The MXT extension nut is a separate item.  I also use their standard barrel clamp, barrel clamp QD mount and barrel clamp Pic rail.  I just run the OEM Beretta follower, it works well.

https://nordiccomp.com/mxt-fit-guide/

https://nordiccomp.com/product-category/shotgun/barrel-clamps-and-clamp-accessories/

 

They also sell a telescoping extension.  I have no experience with it, but according to Nordic, it would be a lot longer than your 21" barrel.

https://nordiccomp.com/categories/telescoping-extension-12ga/

 

Nolan

[Rudukai13]

38 minutes ago, Nolan said:

They also sell a telescoping extension.  I have no experience with it, but according to Nordic, it would be a lot longer than your 21" barrel.

https://nordiccomp.com/categories/telescoping-extension-12ga/

 

Nolan

I’ve seen the telescoping extension, I wish they made one that was roughly flush with the 21” barrel when collapsed because that’d be functionally perfect for a general-purpose shotgun. Only load it up with a few shells when you want to maintain a more compact length, then stuff it full of a bunch of shells when you need to and don’t care about having a javelin

[mmc45414]

Until a week ago I had a 21" Comp (sold to a buddy, just got an A300 Ultima Comp), and the +3 is pretty cool.  But I ended up with several tubes, and might switch them up depending on what the day was planned for, so I do not use a barrel clamp.