BARRYJ Posted May 15, 2023 Share Posted May 15, 2023 After loading about 150 rounds, the priming system locked up. Won't feed primers. Can't move the lever to advance the wheel. Any ideas before I start taking the wrong things apart? Link to comment Share on other sites More sharing options...
BARRYJ Posted May 15, 2023 Author Share Posted May 15, 2023 Nevermind. Played with it a little while and it started working. Must have had some trash in it. Link to comment Share on other sites More sharing options...
m700 Posted May 18, 2023 Share Posted May 18, 2023 The easiest thing to do in that situation is to remove the 2 screws and look at whats going on Link to comment Share on other sites More sharing options...
flyinverted Posted August 8, 2023 Share Posted August 8, 2023 I found that by replacing the stock steel detent ball under the shellplate with a phenolic ball, the amount of powder flung out of the cases dropped by 90%. This powder does foul up the entire press sometimes if you're not doing regular PM. Link to comment Share on other sites More sharing options...
willfully armed Posted August 30, 2023 Share Posted August 30, 2023 On 8/8/2023 at 3:07 PM, flyinverted said: I found that by replacing the stock steel detent ball under the shellplate with a phenolic ball, the amount of powder flung out of the cases dropped by 90%. This powder does foul up the entire press sometimes if you're not doing regular PM. I clipped a coil off the spring, and went with a thrust bearing setup on the shell plate bolt that greatly reduced powder loss. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now