Robertwil18 Posted December 4, 2019 Share Posted December 4, 2019 So, I had an odd "issue" with my Staccato P DUO this evening. I installed a Vario X-Line, short flat, trigger tonight, and upon reassembly, I noticed the installation of this trigger has resulted in a bypass of the grip safety. I detail stripped it, cleaned it once more and reinstalled everything, and it has the same issue. Function check confirms the grip safety is disengaged, but the manual safety remains fully functional. It is otherwise a very smooth and crisp trigger pull, but I have never encountered an issue such as this. The pre travel is significantly shorter with almost zero overtravel and approximately a 3lb trigger pull. It is not a huge issue for me as the manual safety would be engaged during carry anyway, but curious as to what could cause this issue. Any ideas? Link to comment Share on other sites More sharing options...
Rob72 Posted December 4, 2019 Share Posted December 4, 2019 The Vario has scallop cuts on the rear of the trigger bar, which is allowing the trigger to pass under the GS. Link to comment Share on other sites More sharing options...
WhiteDingo Posted December 5, 2019 Share Posted December 5, 2019 Are the pre-travel tabs on the trigger bar adjusted out? Too little pre-travel will not allow grip safety function, as the trigger bar isn't coming far enough forward to allow the safety to reset. Do you have full travel on the grip safety outward? Link to comment Share on other sites More sharing options...
Robertwil18 Posted December 7, 2019 Author Share Posted December 7, 2019 Issue has been resolved. Thank you. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now