Bmans45 Posted November 30, 2019 Share Posted November 30, 2019 Anybody have an idea why the plastic square on the side of the powder measure would break? I have gone through 2 in about 350 rounds . Link to comment Share on other sites More sharing options...
open17 Posted December 1, 2019 Share Posted December 1, 2019 What powder? Really fine powders make the powder slide hard to move. AA7 and SP2 come to mind. Link to comment Share on other sites More sharing options...
Bmans45 Posted December 1, 2019 Author Share Posted December 1, 2019 TG been using it a long time . Never been an issue until I got this new press and powder measure Link to comment Share on other sites More sharing options...
m700 Posted December 1, 2019 Share Posted December 1, 2019 when was the last time you took it apart? could the powder bar be dragging? Link to comment Share on other sites More sharing options...
dillon Posted December 2, 2019 Share Posted December 2, 2019 If either the powder die is down too far, or if the blue wingnut on the bottom of the failsafe rod is too tight, it can cause the rivet on the bellcrank to push too hard on the cube and crack it. If you notice the crack while the cube is still in place, the side of the rivet the crack is on will tell you. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now