Laxman2809 Posted September 29, 2019 Share Posted September 29, 2019 Hello, I have purchased a Tanfo nitro fin and now need to go about fitting it to my gun. Can anyone share some instructions on where to even begin in this endeavor. Link to comment Share on other sites More sharing options...
mro111lland Posted September 29, 2019 Share Posted September 29, 2019 I justed used some 120 grit Emery cloth and worked the diameter down 3 thousand if an inch and then where the spring locked it in I had to smoothen up the noch on the pin Link to comment Share on other sites More sharing options...
Laxman2809 Posted September 30, 2019 Author Share Posted September 30, 2019 1 hour ago, mro111lland said: I justed used some 120 grit Emery cloth and worked the diameter down 3 thousand if an inch and then where the spring locked it in I had to smoothen up the noch on the pin Appreciate the response. If you could share a pic that would be quite helpful. I assume when you say you took emory cloth to the fin, you are talking about just the cylindrical portion. Link to comment Share on other sites More sharing options...
mro111lland Posted September 30, 2019 Share Posted September 30, 2019 Yes it is .003 larger than the cz pin just work it down until it fits right then I polished it up real good then had to do some work to the flat area on the pin also Link to comment Share on other sites More sharing options...
Truckin_Thumper Posted October 2, 2019 Share Posted October 2, 2019 I had to sand the tang corners a wee bit. Wont actually work as a slide lock, but no care Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now