IPSC slide milling for Production Optics

[bimmer1980]

Hi there.

 

I know, you are more USPSA shooters, but maybe someone knows if slide milling is allowed in ipsc prod. optics?

I find it kind of hard to understand the rule.

[perttime]

APPENDIX D4a: Production Optics Division

...

18.2 Aftermarket open and optical/electronic sights (see Rules 5.1.3.1 and 5.1.3.2) and mounting plates are permitted, provided their installation and/or adjustment requires no alteration to the handgun other than the milling of the slide in order to facilitate the installation of an optical/electronic sight.

 

So, that means you can mill the slide to install the sight.

 

Otherwise:

17. Original parts and components offered by the OFM as standard equipment, or as an option, for a specific model handgun on the IPSC approved handgun list are permitted, subject to the following:
17.1 Modifications to them, other than minor detailing (the removal of burrs and/or adjustments unavoidably required in order to fit replacement OFM parts or components), are prohibited....

(which is the same as Production)

[bimmer1980]

21 hours ago, perttime said:

APPENDIX D4a: Production Optics Division

...

18.2 Aftermarket open and optical/electronic sights (see Rules 5.1.3.1 and 5.1.3.2) and mounting plates are permitted, provided their installation and/or adjustment requires no alteration to the handgun other than the milling of the slide in order to facilitate the installation of an optical/electronic sight.

 

So, that means you can mill the slide to install the sight.

 

Otherwise:

17. Original parts and components offered by the OFM as standard equipment, or as an option, for a specific model handgun on the IPSC approved handgun list are permitted, subject to the following:
17.1 Modifications to them, other than minor detailing (the removal of burrs and/or adjustments unavoidably required in order to fit replacement OFM parts or components), are prohibited....

(which is the same as Production)

Thanks a lot!