Dazhi Posted June 28, 2019 Share Posted June 28, 2019 I set off primer only in the gun and they were not loud at all. I used hammer and nail on the defect primers after pulling the bullets out and dumping the powder, because I did not expect they will do anything. This is after I have tried them on factory glocks and mp9s. No gun were able to pop them. So I used hammer and nail. I guess if they indeed go off they may be loud but none of them did. I think the primer QC is an issue for a lot of brands. I know S&B have dimension issues because when I loaded SB exclusively with Pal Filler (an CNCed Italian made vibra prime), a lot of them would not go through the hole - they are made too big. WSP used to be very consistent and no problem, but for the past year I am getting bad batches with these dead primers. Remington is worse than WSP in terms of QC - in both dimension consistency and misfire rate. The only one I can trust right now is Federal/CCI. CCI in particular is hard enough to be safely loaded on 650 per Dillon, and 100% reliable in my guns. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now