rootacres Posted April 26, 2018 Share Posted April 26, 2018 Does anyone know of anyone doing this? Here is my thought process, I know that there is a dovetail on the current MOS models however because of where it is located you don't have the ability to put an adjustable rear sight on. By dovetailing the MOS plate you could add adjustable rear sights to a Glock MOS model. You'd just pop the plate off like a Sig X5 or Walther Q5. Link to comment Share on other sites More sharing options...
RevolverJockey Posted April 28, 2018 Share Posted April 28, 2018 Is the MOS plate tall enough to accommodate a dovetail? Link to comment Share on other sites More sharing options...
LuvDog Posted April 29, 2018 Share Posted April 29, 2018 Interesting idea. The blank plate cover might be thick enough Link to comment Share on other sites More sharing options...
RevolverJockey Posted April 29, 2018 Share Posted April 29, 2018 If you have dovetail specs and an MOS plate I will cut one for you. It might be tough to do on a conventional mill since the plate only has two small screws holding it and the finish is really tough. I could wire the dovetail in on an EDM. Link to comment Share on other sites More sharing options...
rootacres Posted April 30, 2018 Author Share Posted April 30, 2018 On 4/28/2018 at 6:48 PM, RevolverJockey said: Is the MOS plate tall enough to accommodate a dovetail? It appears that there is plenty of room for a dovetail. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now