sandrooney Posted January 22, 2018 Share Posted January 22, 2018 How difficult is it to remove ? Thanks, SR Link to comment
Roy T Posted January 23, 2018 Share Posted January 23, 2018 I have toyed with the idea to install the Odin works button however I have been reluctant to take that step and drill it to fit the OW button only to find in a month they decide to make a complete unit. The factory one fits the flow of the build which makes it a bit tricky to find in a hurry. I have been down too many rabbit holes only to have the market produce a solution so I wait hoping JP or OW will make my life wonderful again Link to comment
sandrooney Posted January 23, 2018 Author Share Posted January 23, 2018 I thought Odin Works did make a complete unit ??? Link to comment
Old3GNR Posted January 23, 2018 Share Posted January 23, 2018 To remove the mag release use a roll pin punch, I think it is 3/32, and tap pin out the bottom. There's another thread on this in this forum. Link to comment
1911luvr Posted January 23, 2018 Share Posted January 23, 2018 There is a step inside the opening from the top, so make sure the punch is 3/32” and NOT 1/8”! Sent from my iPhone using Tapatalk Link to comment
Roy T Posted January 27, 2018 Share Posted January 27, 2018 Sand, They advised me they don't make it for the GMR 15 yet Link to comment
sandrooney Posted January 27, 2018 Author Share Posted January 27, 2018 I found that out. I might drill and tap. Although the stock one is not bad. Maybe I should just practice more. Thanks a lot Roy Link to comment
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now