Taccom shell rack adjustment

[kmca]

My Taccom racks do a very good job of retaining the shells, actually too good. Has anyone sanded/filed on the racks so they release the shell a little easier? Would you use heat and loosen the grip slightly?

Thanks.

[TRUBL]

Which model do you have? If it is the Deuce line of shells, you can go in with some 220 sand paper on the brass side and work that in with your finger.......take a little at a time

The sport series, should not need any work as they only clip onto the plastic hull.

Tim

[kmca]

Mine look like this one.

[TRUBL]

Yep....220 grit sandpaper, little at a time.

That was replaced (just recently) by the 8S4

http://www.taccom3g.com/sport-series-8s4.html

[kmca]

Thanks for the reply TRUBL. I guess I've had them longer than I thought

[mpom]

I wrapped a strip of 220 paper around the shell, clicked it in the caddy and rotated it back and forth a few times, cleaned out residue and checked the tightness. Stop before you go too far

[kmca]

I did that, then buffed them to a shine with a polishing wheel.

Thanks for the replies.