Czechmate questions

[norbyam22]

Wondering if they have any single port comps.

Also looking for angled slide rackers.

Seems like the stock slide racker gets a little close to the thumb.

Any other mods people can think of?

I've seen the thumb rests, so might try it.

https://cpwsa.com/products/cz-czechmate-and-ts-thumb-rest

Might just try and make one...

[jdd817]

I use the same thumbrest you have and like it. For a racker, I use the EGW sidewinder, it fits right in the dovetail for the rear sight.

[norbyam22]

Do you have a picture of that racker on your cz?

[jdd817]

I can post one once I get home.

[jdd817]

Here's the EGW racker installed:

[MrPostman]

Put the dovetail portion of your stock racker in a vise with the racker vertical. Take a propane torch and heat the racker where it should be bent and then bend it some to angle it upwards.

[norbyam22]

jdd817: How do you like yours setup with the smaller cmore? Weight wise, speed of shifting on to targets, recoil

[jdd817]

The weight difference between the two really isn't noticeable. The main reason I went to the RTS2 was for the reduced height over bore. Initially I was using a sideways mount, but I found myself having to always go left to right on short transitions. I wanted to go with an upright dot so that right to left was as good of an option, and the RTS2 was a good middle ground between both desires.