biglou13 Posted October 11, 2015 Share Posted October 11, 2015 A. occasionally loop end of trigger bar spring is out of spec ... not in line with rest of spring how does one fix? B. if spring rides out of groove... how do you fix? Link to comment Share on other sites More sharing options...
crazygiant Posted October 11, 2015 Share Posted October 11, 2015 order a new one. there only $10 from czc http://czcustom.com/cztriggerbarlifterspring.aspx Link to comment Share on other sites More sharing options...
biglou13 Posted October 12, 2015 Author Share Posted October 12, 2015 Sure that's ez fix.... Just seeing if there is another solution should part not be available. I'm going to replace part might as well try a fix the broke one. Link to comment Share on other sites More sharing options...
Toolguy Posted October 12, 2015 Share Posted October 12, 2015 Use needle nose pliers to twist it the direction you want. You will have to go too far because of spring back. Go a little, then more, then more till you get where you want it. Check it between each twist to see where it's at. Link to comment Share on other sites More sharing options...
vixty Posted October 12, 2015 Share Posted October 12, 2015 ^^ yup I've always just bent the spring back. Sometimes if its to bad ill just order a new one from CGW Link to comment Share on other sites More sharing options...
biglou13 Posted October 12, 2015 Author Share Posted October 12, 2015 thanks ill try that do you guys loc tite the screw? work on spring inside while not disassembled? Link to comment Share on other sites More sharing options...
StevenR Posted October 12, 2015 Share Posted October 12, 2015 So far have been able to adjust without removal. Heard removal is a pita as the screw is staked in place. Good luck. Link to comment Share on other sites More sharing options...
crazygiant Posted October 12, 2015 Share Posted October 12, 2015 I didn't have any problem removing mine when I first got it so I could get a good deep clean on the gun, but then again mines a 1992 transitional Link to comment Share on other sites More sharing options...
vixty Posted October 12, 2015 Share Posted October 12, 2015 Your also able to loosen the screw a little to ease some of the tension on the trigger bar. Just don't do it to much of the gun will have issues resetung. I got a noticeable reduction in trigger pull when I loosened mine. Then blue loctite Link to comment Share on other sites More sharing options...
biglou13 Posted October 13, 2015 Author Share Posted October 13, 2015 Gonna try tommorow Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now