CZ SA trigger in Witness?

[VSchneider]

Anybody try fitting the single action triggers made for the CZ-75 in a small frame Witness?

Thanks

Van

[kneelingatlas]

Yup, just ream the holes (Tanfo holes are ~0.5 bigger).

[VSchneider]

Thanks for the information and the quick reply!

Van

[blind bat]

I just did that on a Stock 3 (large frame). At Atlas' suggestion I bought 100+ piece drill bit set from Harbor Freight and stepped up one size at a time. I mic'd the stock roll pin then used a tap handle to hand "drill" the holes. I used a spare CZ flat aluminum trigger I had sitting around. My trigger rests farther forward than it should (not parallel to the grip) and I needed to replace the overtravel screw with a longer (3x0.5x6mm) screw. I might be able to stone down the sear leg to get the trigger parallel to the frame (increasing the pre-travel and reducing the overtravel stops) but I'm leaving it for now because I haven't decided if I want to switch to a Henning trigger.

Edited July 27, 2015 by blind bat

[himurax13]

I look forward to the pics.

I wonder if anyone has installed an 85 combat trigger onto a tanfo. I believe both holes, which are the the same as the Canik trigger Pin, are roughly the same diameter.

Edited July 28, 2015 by himurax13