Brass ejection pattern

[N1vram]

I recently purchased my first glock a gen 4 g20. I've got about 100 to 150 rounds thru it. I've noticed every so often a round will eject and hit me in the head or fly just over my head.

Is this normal? Does the gun need to "break in"?

Thanks

[Jaycwebb]

My Glock 19 did this for a bit when it was new. Stopped after a few hundrew rounds.

[N1vram]

My Glock 19 did this for a bit when it was new. Stopped after a few hundrew rounds.

Thanks. My XD never did this so I wasn't sure. I'll get the round count up and see if stops.

[CB45]

Glock Perfection!

I hear this is common with Gen3, but not so much with Gen4.

Glocktalk forum may have answers for you.'

[Stuck in C]

_{I just got a Model 41 (long slide .45) and it's ejecting straight back; if I wasn't wearing a hat the brass would hit me dead center in the middle of the forehead. I've been shooting Glocks since 1995 and I've never had one do this before. I hope it stops because its good at inducing a flinch.}

[jimreed1948]

I had this same problem too. I didn't see your post until I just post the solution for my problem.

You can see my post here: http://www.brianenos.com/forums/index.php?showtopic=200092

This website will show how I fixed my problem which sounds just like yours. http://www.apextactical.com/blog/index.php/random-apex/apex-glock-extractor-g-fre-fitting/

[N1vram]

_{I just got a Model 41 (long slide .45) and it's ejecting straight back; if I wasn't wearing a hat the brass would hit me dead center in the middle of the forehead. I've been shooting Glocks since 1995 and I've never had one do this before. I hope it stops because its good at inducing a flinch.}

I feel your pain.

[N1vram]

I had this same problem too. I didn't see your post until I just post the solution for my problem.

You can see my post here: http://www.brianenos.com/forums/index.php?showtopic=200092

This website will show how I fixed my problem which sounds just like yours. http://www.apextactical.com/blog/index.php/random-apex/apex-glock-extractor-g-fre-fitting/

Thanks! This might be beyond my skill level. I'm going to ask a friend about this.

[fwrun]

On jimreed's post you can see my reply on the process I took. I didn't have to fit the extractor at all, and I actually ended up with two extractors for the price of one by the time it was all said and done. Apex has great customer service, and they are the only solution I know of that completely rids these new Glock's ejection issues.