Extra followers?

[Vanniek71]

Does anyone know if the followers at CZC will work in the Mec-gar 17 rd mags? I'd like to get some extra followers just in case but am having no luck finding them. or a source where some extras are to be had if these wont work?

it looks similar in the picture but hard to tell for sure.

http://czcustom.com/cz75magazinefollower.aspx

[eerw]

Should work, but will double check for you.

[Vanniek71]

Thank you sir

[eerw]

Checked the followers and the mags.

the MecGar 17rnd mag and the CZ plated mag run a different follower than the CZ 16rnd/SP01 18rnd magazine.

The blue follower is slightly thinner on one portion on the side, which allows it to sit in correct position. the black follower sits too low in the AFC and plated mags.

No doubt you can remove some material if need to, but not a direct replacement.

[Vanniek71]

Damn, thank you for checking.

I may just order some and get my sandpaper on

[Vanniek71]

For anyone who has been trying to contact Mec-Gar to get more followers (and no response of course....

 

Stoegers shop has found the unicorns

 

http://benstoegerproshop.com/cz-17-round-magazine-follower-by-mec-gar-mgcz7517afc/

[B_RAD]

Thanks. I was just thinking it was time to order some of those. 

 

Now I need some 10% springs for the nickel plated Mecgars.