mdschappell Posted February 21, 2014 Share Posted February 21, 2014 To the CZ TS experts out there... I just put on the CZC magwell (the smaller one that is offered) and my factory mags and my mags with the CZC extensions will not fit in the gun. I assume there is some fitting that needs to be done. I want to use the factory mags and the mags with the extensions. What needs to be done to make these fit and function properly? Do you remove material from the magwell or from the mag bases, or both? If you have some pics, please post them. Thanks. Link to comment Share on other sites More sharing options...
Czhase Posted February 21, 2014 Share Posted February 21, 2014 I just picked up the same setup for my TS and am having the same issue, I'm going to open up the mag well a little more, that way I only have to file on one part and not seven individual magazines. Link to comment Share on other sites More sharing options...
Philo_Beddoe Posted February 21, 2014 Share Posted February 21, 2014 To the CZ TS experts out there... I just put on the CZC magwell (the smaller one that is offered) and my factory mags and my mags with the CZC extensions will not fit in the gun. I assume there is some fitting that needs to be done. I want to use the factory mags and the mags with the extensions. What needs to be done to make these fit and function properly? Do you remove material from the magwell or from the mag bases, or both? If you have some pics, please post them. Thanks. I have the CZC large magwell on my TS, my mags with the CZC basepad seated, but it was really tight. I just seated each mag repeatedly until I could see the small marks on both the mag well and basepad where the two were colliding and then removed a small amount of material on each with a small file until it was not so tight. The mags seat fine now and I have had no issues. I think I did most of the filing on the basepads and only a small amount on the magwell. I would call the custom shop before you do anything however. Link to comment Share on other sites More sharing options...
mdschappell Posted February 23, 2014 Author Share Posted February 23, 2014 I ended up opening up the magwell more, at the rear. Once that was done, the extensions didn't require any work. The factory plastic baseplates had to be shaved down a little bit to make them fit. Link to comment Share on other sites More sharing options...
alma Posted February 24, 2014 Share Posted February 24, 2014 I ended up having to do both Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now