Patrick1981 Posted August 26, 2012 Share Posted August 26, 2012 About the firing pin return spring.. Well, it's possible to find a spring that work good with less resistance than the original (and not buy the Apex Kit)? I hear a friend of mine, use in her 625 a firing pin reduced spring made from a pencil spring. Do you have a opinion about this job ? I want to try. Thanks Link to comment Share on other sites More sharing options...
buckaroo45 Posted August 26, 2012 Share Posted August 26, 2012 (edited) If you don't already have one installed, you should purchase the Apex extended firing pin. A lighter spring is included in the bag. Don't know if you can get them in Europe. Otherwise you might try cutting a half turn or more off yours. Good luck. Edited August 26, 2012 by buckaroo45 Link to comment Share on other sites More sharing options...
4mike Posted August 27, 2012 Share Posted August 27, 2012 .... made from a pencil spring...... if you find the pencil with spring made from 0,3mm wire with outside dia. under 4mm you can try if you cannot find it, send me your adress by PM Link to comment Share on other sites More sharing options...
Patrick1981 Posted August 27, 2012 Author Share Posted August 27, 2012 Hi Mike! Luckly I found a spring with the same size in a old box, but I cut it one ring beacase I think is slightly long. In the pics you can see on the left the original, after the reduced that I have on my 686-5 and on the right the new one. This last spring it's more soft. Now I try at home with brass and primers only, waiting for range test. There's some probability it's going good ? I listen any advice Thanks Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now