kpbaer Posted March 4, 2011 Share Posted March 4, 2011 Have been loading 40's on a 550 press with no problems,but switching to 9mm and they seem to stick alot more then the 40's do.the 9mm dies are dillon and the 40's are rcbs. is there any thing I should be going different when loading 9mm verses 40 ?? Link to comment Share on other sites More sharing options...
The_Vigilante Posted March 4, 2011 Share Posted March 4, 2011 Use some Hornady 1-Shot case lube on them before you run them thru your 550. Link to comment Share on other sites More sharing options...
GrumpyOne Posted March 4, 2011 Share Posted March 4, 2011 What kind (make) of brass? Link to comment Share on other sites More sharing options...
kpbaer Posted March 4, 2011 Author Share Posted March 4, 2011 mixed brass Link to comment Share on other sites More sharing options...
GrumpyOne Posted March 4, 2011 Share Posted March 4, 2011 Cleaned? Try some one shot, or get some good silicone spray lube from HD or Lowes, spray some is a 1 gallon ziploc, spray a paper towel, put in the bag, load in about 300 cases, zip shut, and shake a for a minute or two....Should be a whole lot easier to load 'em! Link to comment Share on other sites More sharing options...
BigBets Posted March 7, 2011 Share Posted March 7, 2011 Just to clarify they are sticking in the dies right? Making sure were not talking about the shellplate or something Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now