I have the FART and the FA media separator with lid. I drain most water off, dump brass into the seperator, spin for a minute, drain water, rinse, spin another 30 sec or so, then dump the brass on a towel, and drain the seperator with pins into a bucket with paint strainer. Pull the strainer out with the pins, rinse pins, and store in the strainer till next batch. Any pins that fell to the ground get picked up with the FA magnet. There's rinsing thrown in there as needed. Process really doesn't take long at all and I never got results I was happy with when not using pins. Only exception is I run .223 bras 2x. Once quickly with no pins before decap, size, trim, etc and then a final time with pins. Sent from my SM-G965U using Tapatalk