-
Posts
440 -
Joined
-
Last visited
Content Type
Forums
Profiles
Events
Store
Posts posted by Chapo
-
-
Thanks. I think I'm good now
-
I adjusted the crimp so that now no matter how many times a chamber the dummy round it remains the same IAL
-
I am sorry my OAL is 1.145. It goes down to about 1.40
-
I am testing a load for 9mm major. Ive been doing the plunk test and found perfect OAL of 1.345. However, when I place round(no primer round) in the magazine, chamber it and ejected it, when I Check the OAL again comes out shorter. I've adjusted for a firm crimp but when I check the OAL after round is ejected I notice the OAL is shorter. Is this normal?
-
Thanks all. Great feedback.
-
Gooldylocks, is that with a 124/125gr bullet?
-
Great perspective kneelingatlas!!
-
17 minutes ago, jcc7x7 said:
Bayou 124 gr rn, 6.4 autocomp, fedsrp, col 1.150, out of a 5" bbl 173+pf
Comp build up not a problem with the first 1500 or so, seems flat in my gun.
Splits
Jcc is that out of a Glock?
-
No excuses, Once I tried autocomp with a cast boolit 124gr but had to seat deep to 1.058 so it would chamber and had a catastrophic explosion. Later found out pressure was too much from the seating being to low. So, loading a jhp at 1.15 works for you huh. I guess the type of bullet cast vs jacketed is the difference?
-
Garmil, thanks. Is that load of hs6 with g34 with a compensator? Does it shoot flat? That's my main concern.
-
Thinking of 6.4grs of hs6 with the 124 cmj or 125 HAP at an OAL of 1.13 with a compensator (4ports) and 11 or 13 lb recoil spring. Thoughts?
-
Sorry. Forget all details... 125 HAP
-
It has a LW barrel with the 4 port comp.
-
Looking for the best recipe for a gen 4 g34. I am using this time hs6. I have all competition springs and a 13lbs recoil spring. Carver 4-port comp. looking for a flat experience. I am thinking about 6.4 grains and taking it from there? Thoughts from other g34 open shooters?
Felt recoil
in General Reloading
Posted
So I just came back from the range after shooting a progression of HS6 from 7.4 to 8.3grs. I have a G34 w a carver 4 port comp and an 11lb spring. Also have reduced power plunger spring and striker spring. I recorded the session with my phone, but after viewing all the shots in my phone, I couldn't tell powder amount shot was the flatest. Has this happen to you? I'm inclined to go back to the bench and make more bullets from 6.5 to 7.3grs to see if the gun will cycle and determine if the recoil is less. Any suggestions??