Currently

Is there an adapter that will allow the use of a Lyman 55 powder measure on a 650? I'm planning on operating the measure handle manually when the press is all the way up. This setup will be used for the extruded powders that are difficult to meter with the slide bar measure Dillon uses. I plan to use this setup for load development and low volume match round runs. New to the 650, had a 550 in the mid 80's that I had to sell. Now getting back into it and I will say the landscape has really changed! Don't think I can trust my old manuals with the new powders out today even if they have the same nomenclature. I did buy a new Lyman manual a couple weeks ago.

Never mind ... Did not read rules ...

Hot sunny day, mags on the table soaking up heat, couple of mag dumps and something happened to me.

I bought some aluminum 2in angle ... Screwed it in on three sides of a 7.5 ft wide closet. Picked up a 1.5 inch laminated bamboo countertop, trimmed to fit. Drilled and screwed in from the bottom with deck screws. I can stand on it and jump with no deflection. No legs to capture dust, easy to get under and vacuum AND most importantly, SWMBO likes the way it looks. Accordion doors on closet close when done leaving a clean looking room. No basements where I live ...