splashdown Posted January 23, 2006 Share Posted January 23, 2006 I bought a used SDB last spring/summer and set it up with a new .40 caliber conversion. I've loaded nearly 2k rounds on it and just last night I went to change my powder charge. I threw 15 charges and dumped them back in then threw 10 more to weigh. Repeated the process one more time and all the while noticed that every few cycles of the machine the shellplate didn't index completely to the next station. I removed the shell plate and noted that the ball bearing and spring were in the right spot and it wasn't too dirty in there. I did clean out a little powder and bullet shavings. I'm afraid to load on it in this condition because I don't want to chance blowing any primers on the underside of the shellplate. Any clues what would cause this? splashdown Link to comment Share on other sites More sharing options...
Carmoney Posted January 23, 2006 Share Posted January 23, 2006 Yeah, the metal "finger" on the indexer on the older SDBs was made from a pretty soft alloy that would wear out and need replacement from time to time. The newer indexers are much better--I'd suggest you replace that part (they'll send you one for the asking), and clean and lubricate your machine when you install it, and you should be all set. Link to comment Share on other sites More sharing options...
splashdown Posted January 23, 2006 Author Share Posted January 23, 2006 Thanks for the reply. To replace that part I'd guess I need to take the ram out? I started to do that (for deep cleaning) but couldn't get it out the bottom. What is blocking it? I actually bought the parts kit so I have that metal "finger". I'd also like to replace the plastic rails that guide the ram while I'm in there. Anything else I should replace? Link to comment Share on other sites More sharing options...
Merlin Orr Posted January 23, 2006 Share Posted January 23, 2006 If you can get along without your loader for a little while you might consider sending it to Dillon. They will fix Everything (and I mean everything) and send it back in new condition. Link to comment Share on other sites More sharing options...
Larry White Posted January 23, 2006 Share Posted January 23, 2006 If you use parts from your spare parts kit to fix your press make sure to order those parts from Dillon to restock the kit.------Larry Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now