XCARRY barrel replacement

[TacPrecision]

I have P 320 XCarry (engraved on slide XCarry) , 

I have grey ghost treaded barrel which I want to install on that slide. 
does anyone know is it only required hood fiting or …. 
breafcase is 0.395 and barrel hood is 0.404

[johnmyster]

I fit a Silencerco p320 threaded unit for my x-carry.  Required only narrowing of hood.

[DesertTortoise]

I think there are 2 or 3 versions of the x carry barrel. Would like to know also if you find out. 

 

 

https://ninex19.com/product/sig-p320c-match-barrel/

 

X-CARRY COMPATIBILITY

 

Our P320C / X-Carry barrels fit some X-Carry models, but not all. There was a minor design update made to the X-Carry slide and barrel part of the way through the product life cycle. Our barrels are a direct drop-in fit for the later/current production models, but not the earlier versions. The easiest way to tell which version of X-Carry you have is to look at the bottom of the slide just to the rear of the chamber opening. If there is a “1756” stamped on the inside of your slide, then you have an earlier production version and our barrel will not be compatible. If your slide does not say “1756”, then you have a current production version and our 320C barrel should be a clean fit.

 

 

 

https://www.parkermountainmachine.com/store/p462/P320_X-Carry_Barrel_modification_service.html