dddqqq Posted November 22, 2020 Share Posted November 22, 2020 I’m at 1.07” in my gen 5 Glock 19 barrel. Anyone have any experience with these rounds? at higher lengths like 1.08 and 1.09 I would get the occasional fail to feed and get caught on feed ramps. I doubt it’s the powder load because I used 5.3gr CFE-p for all lengths. i have read in one post the round likes 1.065 can anyone confirm? Link to comment Share on other sites More sharing options...
bowenbuilt Posted November 22, 2020 Share Posted November 22, 2020 Mine run perfectly at 1.106. Been shooting them for years and this is what runs in all my Glocks. Link to comment Share on other sites More sharing options...
Bobkoh Posted November 22, 2020 Share Posted November 22, 2020 10 minutes ago, dddqqq said: I’m at 1.07” in my gen 5 Glock 19 barrel. Anyone have any experience with these rounds? at higher lengths like 1.08 and 1.09 I would get the occasional fail to feed and get caught on feed ramps. I doubt it’s the powder load because I used 5.3gr CFE-p for all lengths. i have read in one post the round likes 1.065 can anyone confirm? Don't shoot Glocks, but my 1911s prefer 1.065. Link to comment Share on other sites More sharing options...
dddqqq Posted November 23, 2020 Author Share Posted November 23, 2020 No one would consider this too short right? 1.065 should run fine in any other gun too I assume? Link to comment Share on other sites More sharing options...
ML123 Posted November 23, 2020 Share Posted November 23, 2020 I wasn't aware of the Gen 5 Glocks chamber being so tight but it is not uncommon on CZ's and a lot of people have asked the same question including myself. I checked out the RMR site and bought some of their 124g JHP to try. Here is a really good post on determining OAL worth reading https://czfirearms.us/index.php?topic=34225.0 Here was a more recent discussion on the subject with a lot of good advice on the topic Link to comment Share on other sites More sharing options...
dddqqq Posted November 25, 2020 Author Share Posted November 25, 2020 From what I have been reading Glock gen 5 barrels have a shorter throat. Does anyone know if they fixed the throat in later gen 5s? Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now