HIREDgun45 Posted April 27, 2020 Share Posted April 27, 2020 16 hours ago, muncie21 said: It took a few strokes of the file (blue area) to get the safety to engage fully. However when I pull the trigger the hammer stops at 'half cock'. Looking at the two safeties I noticed the SV has a lot more material in the area marked in red. I suspect this is where I need to file next. Going to do some more research and if I still have questions, I'll post them in the gun smith portion of this site. The SV safeties are a bit different than most other brands, yhey have a 'Hammer Stop Pad' that you highlighted in red. On SV's site they have some fitting instructions: https://www.sviguns.com/Optifit.php Link to comment Share on other sites More sharing options...
HOGRIDER Posted April 27, 2020 Share Posted April 27, 2020 1 hour ago, HIREDgun45 said: The SV safeties are a bit different than most other brands, yhey have a 'Hammer Stop Pad' that you highlighted in red. On SV's site they have some fitting instructions: https://www.sviguns.com/Optifit.php Looks like an excellent set of instructions! Perform all safety tests. The purpose of these instructions iInfinity OptiFit® - Thumb Safety Gunsmith Fitting * Installation Instructionss not to educate an inexperienced person on the proper fitting and testing of all aspects of safety installation. Installation and testing should only be performed by a trained and experienced professional. Link to comment Share on other sites More sharing options...
HIREDgun45 Posted April 27, 2020 Share Posted April 27, 2020 The harrison pdf that HOGRIDER posted is an excellent guide to figure out where and what you need to cut. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now