Tim300wsm Posted January 5, 2020 Share Posted January 5, 2020 (edited) I’m going to order my 1st witness (a 10mm pro) and am planning to change out the recoil spring, guide rod, hammer spring, firing pin spring and front sight For a fiber one. I plan to use it for a hunting back up and maybe the occasional carry. It will also be used quite a bit as a range toy. My primary concern is reliability. My second biggest concern is a good trigger. Is there anything else I should/shouldn’t do? Thanks ahead of time ETA Watching Memphis mechanics videos on YouTube. Great videos and damn that fingernail looks like it hurt Edited January 5, 2020 by Tim300wsm Link to comment Share on other sites More sharing options...
Popeye212 Posted January 5, 2020 Share Posted January 5, 2020 Watching this I need to make the single action crisper with less travel. Not worried about the double action pull don't plan on using it that way much. Link to comment Share on other sites More sharing options...
Ronemus Posted January 6, 2020 Share Posted January 6, 2020 EGW 1-piece sear really improves trigger feel & allows ~2 lb break. Omega grips look great and fit the hand much better than the factory grips. I had custom springs made to tame the rather vigorous ejection, and use a shock buffer to prevent frame battering. The ejector is also reduced to the minimum. Link to comment Share on other sites More sharing options...
DougM Posted January 6, 2020 Share Posted January 6, 2020 I have a Witness Elite 10mm that I also needed some recoil control over. So I installed a Sprinco Recoil Management System (#19255 for my Witness 10mm) and that seems to keep any frame battering down. Still launches cases into the next zip code, though. I like this recoil spring arrangement and would do it again. Not cheap but if you're going to shoot 10mm, you might want to give it some thought, Link to comment Share on other sites More sharing options...
Popeye212 Posted January 11, 2020 Share Posted January 11, 2020 Put a Wolf recoil (20ib.) and Hammer spring in it made a huge difference. Breaks much cleaner now. Link to comment Share on other sites More sharing options...
ElvisUSMC Posted January 12, 2020 Share Posted January 12, 2020 The 20lb recoil spring is a huge improvement. The stock spring is just that, stock, to all calibers in the Stock III. I've done the full tune on the Stock III (10mm) and it is probably my favorite pistol, and it is absolutely the most accurate. This is accounting for the Shadow 2 with accubushing w/full polish and CGW short reach trigger kit. The Stock III shoots inside it by half. My Stock III 10mm has the confit guiderod, 20lb wolf recoil spring, reduced 14lb hammer spring, and the most important thing, a full polish on all the touching surfaces. I went back to the stock wood grips after getting some flat g10 bogies Lok grips, the fit is better and my hand doesn't get torn up. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now