Production Slide Milling question

[Malarky112]

I apologize if this has been asked before but I tried a search with no luck and I did read the rulebook. Rulebook states milling only for sights allowed. 
 

I have a Shadow1 with an optic plate milled into the slide by CGW. I have an additional plate with a rear sight on it. 
 

if I put the rear sight plate on it it production legal? 

 

 

[rowdyb]

Yes

[Malarky112]

8 hours ago, rowdyb said:

Yes

Thanks rowdy....since you seem to be well versed in IDPA as well would the ruling be the same there or would I be in ESP? 
Thanks! 

[rowdyb]

42 minutes ago, Malarky112 said:

Thanks rowdy....since you seem to be well versed in IDPA as well would the ruling be the same there or would I be in ESP? 
Thanks! 

I'm not super duper idpa rules guy any more, but if ssp let's you mill the slide for other sights, then someone would have to really tell me what that wasn't legal.

[rowdyb]

47 minutes ago, Malarky112 said:

Thanks rowdy....since you seem to be well versed in IDPA as well would the ruling be the same there or would I be in ESP? 
Thanks! 

rule book answered it. no go for ssp. slides may not be milled for other sights in ssp. ( should have known this from my own moment shooting a czc shadow target in ssp nats one year and equipment check didn't catch it and I was ignorant i'd shot with an illegal gun in ssp.)  off to esp you go.

8.2.1.2  letter A.

Edited December 2, 2019 by rowdyb

[Malarky112]

Could be worse...at least I’ll be able to shoot SA. 
Thanks again!