Newbie 650 case feeder question

[rocket99]

I am having an issue where the brass is not being pushed all the way into the shell plate. Where do I make adjustments? See pic below

 

 

 

Sent from my iPhone using Tapatalk

[Sarge]

3 minutes ago, rocket99 said:

 

I am having an issue where the brass is not being pushed all the way into the shell plate. Where do I make adjustments? See pic below

 

 

 

Sent from my iPhone using Tapatalk

 

Is that with handle pushed all the way forward?

[rocket99]

Here is a pic with the handle pushed all the way forward




Sent from my iPhone using Tapatalk

[Roons]

You need to raise the Camming Pin (#9) up a bit by loosening Cam Pin Jam Nut (#4) to allow the Case Insert Slide to move forward a bit more.  Just twist the Camming Pin until it raises up a bit. Assembly Info: https://www.dillonprecision.com/xl650-casefeed-body-assembly_8_45_25386.html

 

If you're still having issues, it might be your Case Insert Slide Spring (#13) is bad/bent/broken. This happened to me though after 30k/40k rounds. It can be found here: https://www.dillonprecision.com/xl650-platform-parts_8_45_25388.html 

 

Hope this helps!

 

Edited February 11, 2019 by Roons

[Sarge]

See that Allen head screw in the aide of the plast thingy? Loosen and slide the Assy forward until it’s touching while holding handle forward then gently retighten

[rocket99]

That fixed it!!! Thanks guys


Sent from my iPhone using Tapatalk