Getting ready to be a proud parent of a new 1050 this week

[IHAVEGAS]

5 hours ago, S&W627shooter said:

I just got my everglades hold down die in the mail today and installed it immediately on my 1050.  I was amazed at the difference.  Before I installed it, my primers were seated flush, now they are well below flush.  You can feel the inside edge of the primer pocket when you rub your finger across the case bottom.  I didn't realize how much the 9mm brass moved in the shell plate.  However, now I guess I need to adjust my primer seater, because they are so deeply seated that the primers are slightly crushed.  LOL  I just got my 1050 and am learning a lot.

 

 

If you used range brass it will be interesting to see if seating depth change is greater or less or about the same on different brands. I'm guessing your shell plate adjustment is something like - turn it down until it rubs then back it off about 1/8 turn.