burttrans Posted October 23, 2014 Share Posted October 23, 2014 The factory magazines do not drop from gun is this normal? I have to pull them out. I know they will loosen up with more use but not sure they will loosen up enough? I am thinking about sanding with very fine sandpaper 800-1000 wet dry where I see they have been rubbing is this a good idea or bad? Any suggestions? Link to comment Share on other sites More sharing options...
TerryT Posted October 23, 2014 Share Posted October 23, 2014 You sure it is not the mag release? I had issues with one of mine that would catch the mag. Cleaned it up with a dremel and some cold blue and no more issues. Link to comment Share on other sites More sharing options...
burttrans Posted October 23, 2014 Author Share Posted October 23, 2014 You sure it is not the mag release? I had issues with one of mine that would catch the mag. Cleaned it up with a dremel and some cold blue and no more issues. I don't think so when I hit mag release the magazine releases good and drops about a 1/2 inch and then just hangs up. Link to comment Share on other sites More sharing options...
alma Posted October 23, 2014 Share Posted October 23, 2014 Take the grips off and try again. Link to comment Share on other sites More sharing options...
Quack Posted October 23, 2014 Share Posted October 23, 2014 Mag brake. Link to comment Share on other sites More sharing options...
burttrans Posted October 23, 2014 Author Share Posted October 23, 2014 Take the grips off and try again. I am trying this as we speak. Link to comment Share on other sites More sharing options...
burttrans Posted October 23, 2014 Author Share Posted October 23, 2014 (edited) Take the grips off and try again. I am trying this as we speak. I am good to go took grips off and released hammer spring I think it was bound up and putting more pressure on magazine that it should have. Thanks that was easy fix. Edited October 23, 2014 by burttrans Link to comment Share on other sites More sharing options...
razorfish Posted October 24, 2014 Share Posted October 24, 2014 I replaced the mag brake with the stainless steel version from CZC (about $10) and the problem went away. Sent from my iPhone using Tapatalk Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now