jstagn Posted January 24, 2014 Share Posted January 24, 2014 (edited) Does anyone other than Guncraft make a short trigger for this gun? Also am looking for a sear spring (3 finger), other than stock, the Wilson one is too short. Thanks.......... Edited January 24, 2014 by jstagn Link to comment Share on other sites More sharing options...
ParaGunner Posted January 24, 2014 Share Posted January 24, 2014 Not sure about the trigger. Try a Ed Brown hardcore or a Infinity tri-glide sear spring. I've used both in my Paras with great success. Link to comment Share on other sites More sharing options...
jstagn Posted January 24, 2014 Author Share Posted January 24, 2014 Thanks, ParaGunner, it looks like the Ed Brown Part 822 has that longer middle finger so it should work. Gunsmith replaced the hammer/sear with the good Wilson parts (original were junk MIM) so no more hammer drop. Am trying to get a 2.5 trigger pull like my old para had. What do you have yours set to? Don't know if the ed brown will help. Link to comment Share on other sites More sharing options...
kmca Posted January 24, 2014 Share Posted January 24, 2014 I had Dlask short triggers in a couple off my guns. I thought I needed them because I have relatively small hands. Replaced them with Dlask medium, no complaints. Link to comment Share on other sites More sharing options...
bmiller Posted January 25, 2014 Share Posted January 25, 2014 Not sure about the trigger. Try a Ed Brown hardcore or a Infinity tri-glide sear spring. I've used both in my Paras with great success. ParaGunner, did you have any issues with main spring housing clearance with the sv sear spring? I tried to put one in my P16 and the tab at the bottom had a round curve and could not get the msh past it. Link to comment Share on other sites More sharing options...
ParaGunner Posted January 27, 2014 Share Posted January 27, 2014 Thanks, ParaGunner, it looks like the Ed Brown Part 822 has that longer middle finger so it should work. Gunsmith replaced the hammer/sear with the good Wilson parts (original were junk MIM) so no more hammer drop. Am trying to get a 2.5 trigger pull like my old para had. What do you have yours set to? Don't know if the ed brown will help. My trigger pull is set to 2.25lbs. I'm using C&S Ultra light trigger group with a Infinity tri-glide sear spring. After the installation of the C&S trigger group I only had to tweak the sear spring to get the pull weight were I want it. Link to comment Share on other sites More sharing options...
ParaGunner Posted January 27, 2014 Share Posted January 27, 2014 Not sure about the trigger. Try a Ed Brown hardcore or a Infinity tri-glide sear spring. I've used both in my Paras with great success. ParaGunner, did you have any issues with main spring housing clearance with the sv sear spring? I tried to put one in my P16 and the tab at the bottom had a round curve and could not get the msh past it. Yes,the tab had to be slightly bent and the I shortened the part of the tab that inserts into the frame because it went to far into the frame rubbing the magazine. Once in,I measured the pull weight and it was 1.5lbs. I bent the center sear leg in until I got to a 2.5lbs trigger pull weight. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now