Ludde Posted September 17, 2013 Share Posted September 17, 2013 (edited) Here are a couple of pictures and a link to my video showing the trigger travel after I have installed a trigger stop & a pre-travel adjustment screws on my Benelli Supernova. The pre-travel adjustment screw is installed as shown in the attached pictures. I found this as the most suitable option after I had "simulated" the trigger movement a bit. I removed a little bit of material in the opening in front of the trigger to allow for proper movement of the trigger. I decided to install the trigger stop screw in the trigger guard behind the trigger. This could also have been installed on the trigger. I have not done any modifications to the sear, disconnector and hammer. Therefore there is still the original trigger creep before it breaks. Video: Edited September 17, 2013 by Ludde Link to comment Share on other sites More sharing options...
flannigun Posted September 19, 2013 Share Posted September 19, 2013 Thanks Ludde, very interesting Keith Link to comment Share on other sites More sharing options...
Jesse Tischauser Posted September 22, 2013 Share Posted September 22, 2013 Nice! I bet it feels way better than factory which could use some improvements. Link to comment Share on other sites More sharing options...
Ludde Posted September 23, 2013 Author Share Posted September 23, 2013 It's a really big difference. Although the trigger pull weight has not been changed it feels lighter and is quite a bit shorter. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now