Rick_L Posted October 4, 2011 Share Posted October 4, 2011 Is there anything that works well to polish the polymer magwell on the inside? I am looking to smooth out the plastic to reduce binding caused from friction on the inside. Link to comment Share on other sites More sharing options...
Jonathan Taliani Posted October 4, 2011 Share Posted October 4, 2011 I would use fine sandpaper. 400-600 should work nicely. Link to comment Share on other sites More sharing options...
Quack Posted October 5, 2011 Share Posted October 5, 2011 are your mag bodies tuned/sized? if not, i would start there. most of my 2011 mags needed to be adjusted. Link to comment Share on other sites More sharing options...
Rick_L Posted October 5, 2011 Author Share Posted October 5, 2011 Thanks Guys. The mags are tuned and sized per the Dawson recommendations. I will give the fine sandpaper a look on a test piece before I go to town on my magwell. Link to comment Share on other sites More sharing options...
leewhiskey Posted October 6, 2011 Share Posted October 6, 2011 Check the magazine release. My mags used to bind just enough on it to make them a little sticky. A little filing and sanding where the mag goes through and they fall clean. Link to comment Share on other sites More sharing options...
Rick_L Posted October 10, 2011 Author Share Posted October 10, 2011 Thanks Lee. I will look at that again next time I clean the gun this week. Link to comment Share on other sites More sharing options...
G17Racing Posted October 18, 2011 Share Posted October 18, 2011 Try the sand paper but i would recommend a finer grit prob 600-800 to reduce excessive marking on the inside. Link to comment Share on other sites More sharing options...
gunfixer Posted October 20, 2011 Share Posted October 20, 2011 (edited) I've read this thread a few times and can't help but wonder if you're experiencing the same issue that I am..?!? My similar thread: Mags Dropping (Or not..) Edited October 20, 2011 by gunfixer Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now