SmokeyB Posted May 4, 2011 Share Posted May 4, 2011 Does anyone have any experience with aftermarket products for the Dillon presses. In particular Unique Tek sells clamp on tool heads-is this good bad or just a gimick? Thanks for any info on these products Link to comment Share on other sites More sharing options...
lynn jones Posted May 4, 2011 Share Posted May 4, 2011 i like it. it removes all the play in the tool head. Link to comment Share on other sites More sharing options...
SmokeyB Posted May 4, 2011 Author Share Posted May 4, 2011 Thank you was it difficult to install? Link to comment Share on other sites More sharing options...
AlamoShooter Posted May 4, 2011 Share Posted May 4, 2011 I don't know about the tool head , but with his powder measure Mico tool = he provides very good directions with his product. I have been tempted many times to get the tool head pins from him and I am very happy with the powder tool Link to comment Share on other sites More sharing options...
SmokeyB Posted May 4, 2011 Author Share Posted May 4, 2011 Good info, sounds like the improvements are worth the cost Link to comment Share on other sites More sharing options...
Jay870 Posted May 4, 2011 Share Posted May 4, 2011 I have the clamping CNC toolhead, the powder baffle, and the "turbo-bearing", all installed on my 550b. Excellent products. Link to comment Share on other sites More sharing options...
roadapple Posted May 4, 2011 Share Posted May 4, 2011 I've been considering the micrometer powder measure and the turbo bearing. Right now, the stock powder measure is spot-on for W 231. The machine so new, I am not very fast with it yet. I'll wait until I have more time loading on it to decide on the turbo bearing. If I decide to use flake powder, I'll probably get the micrometer powder measure. Link to comment Share on other sites More sharing options...
dansy Posted May 5, 2011 Share Posted May 5, 2011 His products are very and is the service. The instruction are also very detail... The powder micrometer is especially good if you change powders....or use a lot of it, some powder do vary quite a bit from lot to lot... Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now