kasen Posted December 12, 2010 Share Posted December 12, 2010 I appear to be failing an IQ test for how to assemble my new Sinclair Expander Mandrel into the Sinclair Std 7/8-14 Expander Die. mandrel die Anyone using these and know how I'm supposed to fit them together? Sinclair's website says something about an O ring... not seeing that. The expander looks like it's one piece. Link to comment Share on other sites More sharing options...
The_Vigilante Posted December 12, 2010 Share Posted December 12, 2010 Unscrew the cap on die and insert mandrel. If no O-ring came with the die go to Home Depot, etc and find one that fits inside the die cap Link to comment Share on other sites More sharing options...
Corey Posted December 12, 2010 Share Posted December 12, 2010 cap should come right off and the mandrel drops in, then the cap holds it in place. it should be a pretty painless install. Link to comment Share on other sites More sharing options...
kasen Posted December 12, 2010 Author Share Posted December 12, 2010 cap should come right off and the mandrel drops in, then the cap holds it in place. it should be a pretty painless install. That's embarrassing. Yes, indeed it took a little more effort to unscrew but it was that simple. Link to comment Share on other sites More sharing options...
Corey Posted December 12, 2010 Share Posted December 12, 2010 good deal. make sure when you're sizing the brass, you set the die up so the case neck doesn't bottom out against the base of the mandrel. you don't need to make a full press stroke, just enough to get the mandrel fully into the case mouth then back out. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now