Extrema 2

[TxD]

I am trying to get my Extrema 2 set up for 3gun limited.

I have the extended tube, (10 Rd- need to make a plug) extended bolt release etc.

I am looking for advice on loading port mods.

In the following question I am calling the bolt release claw,

the part that captures and holds the shells in the magazine tube.

There is a small protrusion just above the bolt release claw that kicks the shell off center when re-loading through the port.

Can this be cut down? I realize that it shouldn't be completely removed as as you would be pushing on the bolt release claw

with each shell when loading.

I have seen pics of the Benelli port mods in this forum but no Extrema.

Does anyone have pics of a modified Extrema loading port?

Are there other recommended mods?

Thanks in advance.

[whiskey1]

Try a PM to Benelli2. He ran an Extrema to good effect for a while. I understand though that he now has the first Benelli Vinci ever set up for our game...He seems to know a little about a lot.

[caspian guy]

You might also try a pm to stefan. I believe he still runs an extrema...

[bushmeat]

I am trying to get my Extrema 2 set up for 3gun limited.

I have the extended tube, (10 Rd- need to make a plug) extended bolt release etc.

I am looking for advice on loading port mods.

Why are you trying to modify the loading port? I've borrowed and used an Extrema 2 and it is really slick to load with either hand. If I could afford one, I'd get it. My own FN SLP on the other hand, tried to amputate my left thumb several times until I got the lifter welded.